ACTIVE INGREDIENT:

Fluroxypyr-meptyl........................................................................................................ 10%

MCPA.......................................................................................................................... 30%

INERT INGREDIENT...................................................................................................... 60%

TOTAL:100%

For control of annual broad-leaved weeds, including cleavers, wartwort, descurainia, henbit, shepherd's purse, Common chickweed, Common poppy, Mayweeds, etc. in wheat, barely, corn, paddy, lawn etc.

DANGER

May be fatal if swallowed and enters airways.

May cause damage to organs through prolonged or repeated exposure. Causes skin irritation.

Causes serious eye irritation.

May cause an allergic skin reaction. May cause drowsiness or dizziness. Avoid breathing spray.

Forbidden to use nearby aquaculture regions and ponds. Forbidden to clean spray equipment in ponds.

Clean spray equipment immediately after use.

Clean used empty packages three times, dispose them properly, and be sure not to reuse them or for other use.

Keep out of reach of pregnant women, nursing mothers and children. Wear protective gloves/protective clothing/eye protection/face protection. DO not drink or smoke when using.

Use soap and water to clean face and hands after use.

FIRST AID

IF ON CLOTHING: Remove contaminated clothing immediately, then deal with it properly. IF ON SKIN: Rinse contaminated skin thoroughly with plenty of soap and water. If not, please go to a doctor.

IF IN EYES: Open eyelids immediately, rinse them cautiously for 15-20 minutes. Remove contact lenses, if present and easy to do, then continue rinsing. If not, please go to a doctor.

IF IN MOUTH: Rinse your mouth with water, don't induce vomiting, and then go to a doctor.

Dispose of contents/container to a licensed hazardous waste disposal contractor or collection site except for empty, clean containers which can be disposed of as non-hazardous waste. Wash hands thoroughly after handling.

To avoid risks to human health and the environment, comply with the instructions for use.

IMPORTANT INFORMATION

FOR PROFESSIONAL USE ONLY AS AN AGRICULTURAL HERBICIDE

Other specific restrictions:

If amount of spray is not enough, burning spots may occur in the wheat leaves, but it does not affect the normal growth of crop.

SAFETY PRECAUTIONS

Operator Protection

Engineering control of operator exposure must be used where reasonably practicable, in addition to the following personal protective equipment:

WEAR SUITABLE PROTECTIVE CLOTHING (COVERALLS), SUITABLE PROTECTIVE GLOVES AND

FACE PROTECTION (FACESHIELD) when handling the concentrate. TAKE OFF IMMEDIATELY all contaminated clothing.

WASH ALL PROTECTIVE CLOTHING thoroughly after use, especially the insides of gloves.

WASH HANDS AND EXPOSED SKIN before eating and drinking and after work. WHEN USING DO NOT EAT, DRINK OR SMOKE.

IF YOU FEEL UNWELL, seek medical advice immediately.

ENVIRONMENTAL PROTECTION

Do not contaminate water with the product or its container. Do not clean application equipment near surface water. Avoid contamination via drains from farmyards and roads. To protect aquatic organisms respect an unsprayed buffer zone to surface water bodies in line with LERAP requirements.

STORAGE AND DISPOSAL

KEEP IN ORIGINAL CONTAINER, tightly closed, in a safe place.

WASH OUT CONTAINER THOROUGHLY, empty washings into spray tank and dispose of safely.

DO NOT RE-USE CONTAINER FOR ANY PURPOSE.

THIS MATERIAL AND ITS CONTAINER must be disposed of in a safe way. KEEP OUT OF REACH OF CHILDREN.

KEEP AWAY FROM FOOD, DRINK AND ANIMAL FEEDINGSTUFFS.

DIRECTIONS FOR USE

IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.

GENERAL INFORMATION

THE PRODUCT is a contact herbicide which is mainly absorbed by the leaves. The optimum timing is to apply THE PRODUCT E when the weeds are small and actively growing.

RESTRICTIONS OR WARNINGS

DO NOT apply when crop is under stress, such as in frosty weather or when frost is expected, insect attack, manganese deficiency, wind damage or where there is possible check from earlier pesticide treatments.

DO NOT overlap spray swaths.

Extreme care must be taken to avoid spray drift onto non-crop plants outside of the target area.

Applications of THE PRODUCT may cause transient symptoms of phytotoxicity.

RESISTANCE

THE PRODUCT contains two active ingredients with different modes of action and therefore the risk of resistance building up is reduced.

Repeated use of herbicides with the same mode of action can increase the risk of strains of weeds developing resistance to these compounds, leading to poor control. In order to minimize the risk, a strategy for preventing and managing such resistance should be adopted.

Growers are advised to apply products containing herbicides with different modes of action in sequence or tank-mix where two or more components are active against the target weeds.

Use the recommended rate of THE PRODUCT and the correct application timing for the hardest to control weed species present in the field.

The above should be used in conjunction with effective cropping rotation and cultivation techniques e.g. stale seedbed, cultivation and use of non-selective herbicide prior to drilling.

RATE OF USE AND WATER VOLUME

Apply THE PRODUCT at 0.5-0.75 L/ha in 200-300 litres water per hectare as a MEDIUM spray. The lower rate should only be used on susceptible weed species that are small and actively growing at the time of application. For more details see weed susceptibility table above.

Qualified recommendation: lower water volumes of 100 L/ha may also be used, however these have not been supported by effectiveness or crop safety data. As THE PRODUCT has contact activity, it is important to achieve a good coverage of the crop when spraying.

SUCCESSION CROPS

Cereals, maize, sugar beet, oilseed rape, grass, carrots, sunflowers and peas may be sown in the calendar year following treatment with THE PRODUCT. There is no need to plough before drilling the following crop. In the event of crop failure for any reason these crops may also be sown, although vigour reductions in following crops of oilseed rape may be seen after a dry summer. This will be outgrown and will not result in yield loss.

MIXING AND SPRAYING

For use by tractor mounted/trailed sprayer only. Ensure the sprayer is clean and in good working order. Calibrate according to the sprayer manufacturer's recommendations.

Half-fill the spray tank with clean water and begin agitation. Add the required quantity of THE PRODUCT to the tank and complete filling. Continue agitation until spraying is complete.

On emptying the container, RINSE CONTAINER THOROUGHLY by using an integrated pressure rinsing device or manually rinsing three times. Add washings to sprayer at time of filling and dispose of container safely.

Do not leave the sprayer standing with the spray mixture in it for a long period of time.

TANK-MIXTURES

Where tank-mixes are used, and unless directed otherwise, the preferred order of addition of products to the spray tank is as follows: water dispersible granules, wettable powders, suspension concentrates (flowables), emulsifiable concentrates, solution concentrates. Each product should be added to the half-full sprayer and be fully dispersed before the addition of the next product.

COMPATIBILITY AND SEQUENCES

THE PRODUCT must not be used in mixture or in sequence with any other product containing an ALS inhibitor.

SPRAY TANK CLEANING

To avoid subsequent damage to crops other than cereals immediately after spraying thoroughly clean all spray equipment including inside and outside of the lid using ALL CLEAR EXTRA sprayer cleaner according to the following label instructions.

1. Immediately after spraying, drain tank completely. Any contamination on the outside of the spraying equipment should be removed by washing with clean water.

2. Rinse inside of tank with clean water and flush through boom and hoses using at least one-tenth of the spray tank volume. Drain tank completely.

3. Half-fill tank with clean water and add ALL CLEAR EXTRA at the recommended rate.

Agitate and then flush the boom and hoses with the cleaning solution. Top up with water making sure the tank is completely full and allow to stand for 15 minutes with agitation. Again flush the boom and hoses and drain tank completely.

4. Nozzles and filters should be removed and cleaned separately with an ALL CLEAR EXTRA solution containing 50 ml of ALL CLEAR EXTRA per 10 litres of water.

5. Rinse the tank with clean water and flush through the boom and hoses using at least one-tenth of the spray tank volume. Drain tank completely.

DISCLAIMER/CONDITIONS OF SUPPLY

The specified properties of our products and the mode of application stated on this label have been established on the basis of research and experience. Products conform to specification at the time of delivery but, as we exercise no control over their subsequent storage, handling, mixing or use or the weather conditions before, during and after application, all of which may affect the performance of the products, no responsibility or liability will be accepted by us or our re-sellers for any failure in performance, damage or injury to person or property whatsoever arising from the storage, handling, application or use of the products. These conditions cannot be varied by our staff or agents whether or not they supervise or assist in or make recommendations concerning the use of such products. We recommend you contact your dealer to request advice on the suitability of this product for any new and/or unusual growing methods or for new varieties not listed on this label.

READ THE LABEL BEFORE USE. USING THIS PRODUCT IN A MANNER THAT IS INCONSISTENT WITH THE LABEL MAY BE AN OFFENCE. FOLLOW THE CODE OF PRACTICE FOR USING PLANT PROTECTION PRODUCTS.